Spring Wreath with Mesh 

What you will Need:

• 16" Wire Wreath Frame
• 2 10 yard roll of 21" wide mesh Green and Hot Pink
• Matching color chenille stems or I used pipe cleaner
• Spring Flowers
• Large Sheer Butterfly
• Hot Glue Gun
• Measuring tape

Next cut 22 stems around the wreath frame alternating between the outside and then inside of the rings and space them evenly.

The the mesh and gather the end. Place the gathered end over a stem and twist the stem to secure.

Measure the mesh 16" apart and gather keeping it as straight as possible.

Place the gathered area over the next stem and twist. 

Continue measuring, gathering, and securing the loops infill there are only 5 stems without mesh loops.  Check to make sure you have enough to make the 16" loops. If not then make the loops a little smaller. You will never know the difference. 

Take the green mash and tie it to the stem that is securing the pink mesh and twist and secure it. Doing the same as the pink continue around the wreath continue to measuring, gathering, and securing loops. Make sure to fluff, straighten, and position the loops to make the wreath full all over. 

Gather the flowers and fern stems into a bouquet and wrap with wire. Use stem to secure the bouquet to the wreath.  Glue the butterfly onto the flower with the hot glue gun.

Secure a loop to the back to hang on the wall or the door.